Oxyguard Oxygen Standard Probe
Item number : 1OXSP001
Manufacturer : Oxyguard
Type of probe: Galvanic cell
Self temperature compensating
Anode & membrane may be replaced
Two wire cable
1 year warranty
Made in Denmark
- Additional information
OxyGuard oxygen Standard Probe is hermetically sealed. If needed you can open it to replace the membrane and renovate it completely, but this should not be needed for many years.
The measurement stability of the OxyGuard Standard Probe is also very high indeed. A probe measuring in air will maintain accuracy even when subjected to a sudden 20 degree celcius temperature change. The sensitivity of a probe measuring in clean air at room temperature will remain the same for at least 3 years. This proves that the OxyGuard probe is not, like some other probes, affected by “ageing”.
OxyGuard believe that the OxyGuard Standard probe is more accurate, needs less attention and maintenance and has a lower total cost of ownership than any other oxygen or dissolved oxygen probe offered to the aquaculture industry today.
Flow requirements: typically 1 cm/sec
Range: 2.5 to 5 mV per O2 ppm (mg/L)
Operating conditions: 0 to 40°C; Submersible to 50 meters
Compatible with salt water
Standard accessoiries: 5 spare membranes with O-ring and 50 ml electrolyte*
Weight: 0.4 lbs. (0.2 kg)
Dimensions: 2.5" x2.25 " diam (5.8 cm x 5.9 cm diam)
*Accessories are shipped with every OxyGuard probe. You will thus be able to change the membrane. Otherwise the accessories can be enough for up to 5 years’ use.
Item number : 1OXSS134
Quantity: 1 L
OxyGuard Oxygen Probe service kit223.37$
Item number : 1OXPA047
Quantity: 10 membranes & O-rings, 2 anodes, 2 cathode cleaning pads, 1 tool , 1 L electrolyte
OxyGuard Type III Anode17.65$
Item number : 1OXSS033
Probe Membrane (%) with O-Ring46.83$
Item number : 1OXSA002
Quantity: 10 membranes & O-rings
|Dimensions||8 × 8 × 2.5 cm|